Search

What didn’t work so well

There is surprisingly not too much to add here – and most of the things are based around a bit of functionality over-kill!

Mains in & battery charger

I wouldn’t bother in the future. The panel and split charge is more than enough.

Seat upholstery

This could just be done better, by not leaving enough space to add the fabric it made these super tight together. I may well redo the base of the chair at some point.

Sliding door cladding (top)

The top of the door is a little wide, I could have done with a bit less cladding-added depth here. But really its no big deal.

More space on electronics board

Because I had to change the smaller Charge Controller for a bigger one – it would have been useful to know this from the start.


Ventilation

This is not really a real problem, we had some SUPER hot days in Paris and the van was warm at night. Half cracking the doors gives good added ventilation but perhaps an added ceiling vent would have helped. Its not always ideal to have the doors slightly opened.

That said, these do not look stealthy and feel such bad quality for money. I did look at yacht port holes – but these are very expensive.

If I was to build again I would re-look in to it – but I am not sure I would change what I have done.

Extraction fan

It is a bit noisy – perhaps there is a better solution – without losing too much stealth element.


Get the Van Conversion Guide:

https://www.thevanconversionguide.com/

20 views

© 2019 Nate Murphy

Thank you for being you!